Ford Mustang (1999-2004) Service Manual: Noise, Vibration and Harshness
- Noise, Vibration and Harshness (NVH) (Description and Operation)
- Electronic Vibration Analyzer (EVA)
- Vibrate Software
- Tracing Powder
- Index Card
- Noise, Vibration and Harshness (NVH) (Diagnosis and Testing)
- Tire Wear Chart
- Brake Disc Machining
- Powertrain/Drivetrain Mount Neutralizing
- Exhaust System Neutralizing
- Wheel Bearing Check
Exceptions To Normal Schedule
Yellow Coolant
Change coolant at 5 years or 160,000 km (100,000 miles) of the vehicle's
life, whichever comes
first.
After the initial change, change coolant every 3 years or 80,000 km
(50,000 ...
Noise, Vibration and Harshness (NVH) (Description and Operation)
Noise is any undesirable sound, usually unpleasant in nature. Vibration is
any motion, shaking or
trembling, that can be felt or seen when an object moves back and forth or up
and down. Harshness is ...
Other materials:
Differential Case and Ring Gear
Special Tool(s)
2-Jaw Puller
205-D072 (D97L-4221-A) or
equivalent
Installer, Differential Side
Bearing
205-009 (T57L-4221-A1)
Step Plate
205-D016 (D80L-630-5) or
equivalent
...
Trim Panel - Quarter, Coupe
Removal and Installation
1. Remove the upper quarter trim panel. For additional information,
refer to Trim Panel-Upper
Quarter in this section.
2. Remove the scuff plate.
3. Remove the pin-type retainers.
4. Lower the rear seat backrests.
5. Rem ...
Removal
1. Disconnect the battery ground cable. For additional information, refer
to Section.
2. Raise and support the vehicle. For additional information, refer to
Section.
3. Place a drain pan under the transmission fluid pan.
4. Drain transmission fluid.
...