Ford Mustang (1999-2004) Service Manual: Service Information
- Identification Codes
- Vehicle Identification Number (VIN) Locator
- Vehicle Certification (VC) Label Locator
- Paint Codes
- Interior Trim Codes
- Spring Codes
- Unique Calibration
- Jacking and Lifting
- Maintenance Schedule
- General Maintenance Information
- Special Operating Condition Requirements
- Checks and Services
- Normal Schedule
- Exceptions To Normal Schedule
- Noise, Vibration and Harshness
- Noise, Vibration and Harshness (NVH) (Description and Operation)
- Electronic Vibration Analyzer (EVA)
- Vibrate Software
- Tracing Powder
- Index Card
- Noise, Vibration and Harshness (NVH) (Diagnosis and Testing)
- Tire Wear Chart
- Brake Disc Machining
- Powertrain/Drivetrain Mount Neutralizing
- Exhaust System Neutralizing
- Wheel Bearing Check
Other materials:
Inspection and Verification
1. Verify customer concern by running the engine.
2. Inspect the drive belt for chunking, fraying and wear.
3. Check the drive belt for correct routing.
Drive Belt Cracking/Chunking/Wear
V Ribbed Serpentine Drive Belt With Cracks Across Ribs
The accessory ...
Disassembly
1. Remove the retaining ring above fifth gear.
2. CAUTION: Hand tighten the special tool to prevent gear damage.
CAUTION: Support the output shaft while using the press to prevent
damage to the
shaft or gears.
Using the special tool, press fifth gear, the s ...
Idle Air Control (IAC) Valve - Mach I
Removal and Installation
1. Remove the air intake scoop. For additional
information, refer to Section.
2. Disconnect the idle air control (IAC) valve electrical connector.
3. Remove the bolts, the IAC valve and the gasket.
4. NOTE: Install a new ga ...
