Ford Mustang (1999-2004) Service Manual: Oil Level Indicator and Tube

Removal and Installation

1. Remove the oil level indicator tube (6754).

  • Remove the bolt.
  • Remove the oil level indicator tube.
  • Remove and discard the oil level indicator tube O-ring.

Oil Level Indicator and Tube

2. To install, reverse the removal procedure.

Oil Level Indicator and Tube

    Installation
    NOTE: Do not use a fiber disc to clean the surfaces. Fibers from the disc can get into the oil pan and oil and clog the oil bypass valve. 1. Clean and inspect the cylinder head for flatness. 2. ...

    Oil Pan
    Special Tool(s) 3 Bar Engine Support Kit 303-F072 Lifting Bracket Set, Engine 303-D095 (D94L-6001-A) or equivalent Material ...

    Other materials:

    Removal
    1. Remove the upper intake manifold. For additional information, refer to Intake Manifold-Upper in this section. 2. Disconnect the fuel line. For additional information, refer to Section. 3. Remove the coolant by-pass tube. For additional information, refer ...

    Inspection and Verification
    1. The interior lighting system is a generic electronic module (GEM) controlled system. 2. Verify the customer concern by operating the interior lighting system. 3. Visually inspect for the following obvious signs of mechanical and electrical damage. ...

    Transmission Fluid Cooler Tubes
    Removal 1. Disconnect the battery cables. 2. Raise and support the vehicle. For additional information, refer to Section. 3. Remove the nuts. 4. Remove the fluid cooler tube bracket at the engine. 5. NOTE: Use a backup wrench to hold the case fitting sec ...