Ford Mustang (1999-2004) Service Manual: Oil Pan
Special Tool(s)
![]() |
3 Bar Engine Support Kit 303-F072 |
![]() |
Lifting Bracket Set, Engine 303-D095 (D94L-6001-A) or equivalent |
Material

Oil Level Indicator and Tube
Removal and Installation
1. Remove the oil level indicator tube (6754).
Remove the bolt.
Remove the oil level indicator tube.
Remove and discard the oil level indicator tube O-ring.
2. To ...
Removal
1. Disconnect the battery ground cable.
2. Remove the air cleaner outlet pipe.
3. Remove the radiator sight shield.
4. Remove the coolant recovery reservoir.
1. Disconnect the hose.
2. R ...
Other materials:
Pinpoint Test A: The Air Bag Warning Indicator Is Illuminated Continuously
- RCM
Disconnected, Inoperative or Lost/Low Ignition Feed
Normal Operation
NOTE: During normal operation the air bag indicator will be lit continuously
for 6 seconds after the
ignition switch is placed in the RUN position and after five cycles of a lamp
fault code (LFC) if a fault
exists. Be sure to cycle the ignit ...
Crankshaft Position (CKP) Sensor - 4.6L
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the A/C compressor. For additional information, refer to
Section.
3. Remove the crankshaft position (CKP) sensor.
Disconnect the connect ...
Supercharger Belt Tensioner
Removal and Installation
1. Remove the supercharger drive belt cover.
2. Rotate the supercharger belt tensioner clockwise and remove the
supercharger belt.
3. Remove the bolts and the supercharger belt tensioner.
4. To install, reverse the removal proced ...


