Ford Mustang (1999-2004) Service Manual: Rear Bumper

Removal and Installation

All vehicles

1. Remove the rear bumper cover. For additional information, refer to Rear Bumper Cover in this section.

2. Remove the rear bumper cover isolator.

Vehicles with 4.6L engines

3. Remove the bolts and the exhaust outlet pipe bumper bracket.

Rear Bumper

All vehicles

4. Remove the rear bumper brace and tongue bolts.

Rear Bumper

5. Remove the bolts and the rear bumper.

Rear Bumper

6. To install, reverse the removal procedure.

 

    Front Bumper
    Special Tool(s) Heavy-Duty Riveter 501-D011 (D80L-23200-A) Removal and Installation All vehicles except Cobra 1. Remove the front bumper cover. For additional information, refer to Fro ...

    Safety Belt System
    Torque Specifications ...

    Other materials:

    Valve Spring Strength
    Special Tool(s) Pressure Gauge, Valve/Clutch Spring 303-006 (TOOL-6513-DD) or equivalent 1. Use a Valve/Clutch Spring Pressure Gauge to check the valve spring for correct strength at the specified valve spring length. Refer to the appr ...

    Acceleration Control (Diagnosis and Testing)
    Inspection and Verification 1. Verify the customer's concern by operating the acceleration control system to duplicate the condition. 2. Inspect to determine if any of the following mechanical concerns apply: Visual Inspection Chart Mechanical ...

    Warning lamps and indicators
    These indicators can alert you to a vehicle condition that may become serious enough to cause expensive repairs. Many lights will illuminate when you start your vehicle to make sure they work. If any light remains on after starting the vehicle, refer to the re ...