Ford Mustang (1999-2004) Service Manual: Reverse Sun Gear
Disassembly
1. Remove the reverse clutch sun gear assembly and the No. 4 forward clutch hub bearing and race.
2. Remove the forward clutch sun gear assembly and the No. 5 forward clutch sun gear bearing and race.
Assembly
1. The forward clutch sun gear and reverse sun gear assembly are assembled as part of the transmission assembly procedure.
Planetary Gear Support Assembly and Planetary One-Way
Clutch
Disassembly and Assembly
1. NOTE: Inspect the outer and inner races for scores or damaged
surface areas where rollers
contact the races. Inspect the rollers and springs for excessive wear ...
Output Shaft and Direct Clutch Cylinder
Special Tool(s)
Compressor, Clutch Spring
307-015 (T65L-77515-A)
Protector, Piston Seal
307-080 (T80L-77234-A)
Protector, Transmission Direct
Clutch Outer Flui ...
Other materials:
Dowels - Flywheel
Removal
1. NOTE: Take care not to damage the flywheel dowel holes or the
surface areas around the
flywheel dowel during removal.
Remove the flywheel dowels by using a drift pin where the flywheel dowel is
installed in an open
hole and a pair of lockin ...
Assembly
1. CAUTION: Before beginning assembly, carry out and inspect the
following:
When building up subassemblies and assembling the transmission, ALWAYS use new
gaskets and seals.
All fasteners must be tightened to the torque specification indicated. In
addition ...
Crankshaft Pulley
Special Tool(s)
Remover, Crankshaft Vibration
Damper
303-009 (T58P-6316-D)
Installer, Crankshaft Vibration
Damper
303-102 (T74P-6316-B)
Material
Item
Specification
Silicone Gasket and Sealant
F7AZ-19554-EA or eq ...
