Ford Mustang (1999-2004) Service Manual: Seat Track
Removal and Installation
1. Remove the front seat. For additional information, refer to Seat-Front Power in this section.
2. Remove the outboard seat trim shield.
3. Disconnect the electrical connector.
4. Remove the seat track bolts.
5. To install, reverse the removal procedure.
Seat - Front Power
Removal and Installation
1. Remove the safety belt through the opening in the safety belt guide.
2. Move the seat forward.
3. Remove the bolt covers and remove the seat track bolts.
4. Move the ...
Lumbar Motor
Removal and Installation
All vehicles
1. Remove the front seat. For additional information, refer to Seat-Front
Power in this section.
2. Disconnect the power seat track electrical connector.
...
Other materials:
Switch
Removal
1. Remove the climate control assembly. For additional information, refer to
Control Assembly in
this section.
2. NOTE: All three switches are removed the same.
Remove the knob.
3. Remove the screw.
4. Rotate the switch and remove it from the cont ...
Retractor - Rear Seat Safety Belt, Coupe
Special Tool(s)
Torx Bit, Safety Belt Bolt
501-010 (T77L-2100-A)
Removal
1. Remove the quarter trim panel (31012) and the angel wing trim. For
additional information, refer
to Section.
2. Using the special tool, remove the D-ring bolt.
3. U ...
Four Wheel Anti-Lock Brake System (4WABS) Hydraulic Control Unit (HCU)
NOTE: This procedure only needs to be performed if the 4-wheel
anti-lock brake (4WABS) hydraulic
control unit (HCU) has been installed new or if the HCU lines have been
opened.
1. Clean all dirt from and remove the brake master cylinder filler cap
...
