Ford Mustang (1999-2004) Service Manual: Removal

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. If substitution is necessary, the part must be of the same finish and property class. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. Raise the vehicle on a hoist.

2. Support the No. 1 crossmember with a jack stand.

3. Remove both wheel and tire assemblies.

4. Remove both mufflers.

5. Remove the driveshaft.

6. Disconnect the parking brake cable and conduits from the parking brake levers.

Spring - Cobra

7. Remove the clip and disconnect the parking brake cable and conduits from the rear brake calipers.

Spring - Cobra

8. Disconnect the parking brake cable and conduits from the knuckles (5A968/5A969).

Spring - Cobra

9. Remove the bolts and the parking brake cable brackets.

Spring - Cobra

10. Remove the bolts and the rear brake lines.

Spring - Cobra

11. Remove the bolts and the ABS sensors.

Spring - Cobra

12. Unclip the ABS sensor wires from the subframe.

Spring - Cobra

13. Support the lower suspension arm and bushings (5A649) with jack stands.

14. Remove the nuts, bolts and disconnect the shock absorbers (18125) from the lower suspension arm and bushings. Discard the bolts and nuts.

Spring - Cobra

15. Lower the lower suspension arm and bushings and remove the jack stands.

16. Support the rear subframe using the special tool 014-00765.

17. Remove and discard the nuts from the subframe front bolts.

Spring - Cobra

18. Remove and discard the subframe rear bolts.

Spring - Cobra

19. Remove the springs (5560).

1. Carefully lower the subframe with the special tool 014-00765, allowing the subframe to pivot on the front bolts.

2. Remove the springs and the spring insulators (5536).

Spring - Cobra

    Spring - Cobra
    Special Tool(s) Rotunda Powertrain Lift 014-00765 or Equivalent ...

    Installation
    1. NOTE: Inspect the spring insulators for wear or damage. Install new spring insulators if necessary. Make sure the spring insulators are correctly installed on the springs. 2. Install the spring ...

    Other materials:

    Deactivation
    WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment. WARNING: Carry a live air ...

    Safety Belt Buckle - Front Seat
    Removal Driver and passenger seat 1. Remove the front seat. For additional information, refer to Section. 2. Remove the nut and the safety belt buckle. Driver seat only 3. Disconnect the safety belt buckle electrical connector. Installation 1. To install, ...

    Component Tests
    Steering Linkage 1. NOTE: Excessive vertical motion of the studs relative to the sockets may indicate excessive wear. With the parking brake applied, perform the following: Have an assistant rotate the steering wheel back and forth 360 degrees and watch ...