Ford Mustang (1999-2004) Service Manual: Supercharger Belt Idler Pulley

Removal and Installation

1. Remove the supercharger drive belt cover.

Supercharger Belt Idler Pulley

2. Rotate the supercharger belt tensioner clockwise and remove the supercharger belt.

Supercharger Belt Idler Pulley

3. Remove the bolt and the supercharger belt idler pulley.

Supercharger Belt Idler Pulley

4. To install, reverse the removal procedure.

 

    Accessory Drive Belt Idler Pulley - 4.6L (2V) and (4V)
    Removal and Installation Mach I 1. Remove the air intake scoop. For additional information, refer to Section. Cobra 2. Remove the supercharger drive belt cover. 3. Rotate the supercharger belt tensi ...

    Starting System
    General Specifications Torque Specifications ...

    Other materials:

    Driveline System
    Special Tool(s) Clamp Plate 205-320 (T92L-4851-C) Clutch Housing Alignment Adapter 308-021 (T75L-4201-A) Companion Flange Holding Tool 205-126 (T78P-4851-A) Companion Flange Runout Gauge 205-319 (T92 ...

    Actuator Cable - Speed Control-Cobra
    1. Remove the speed control actuator cable end from the throttle body. 1. Lift the speed control cable from the throttle nailhead. 2. Release the speed control cable from the throttle bracket. 2. Remove the speed control cable from the retaining cli ...

    Inspection and Verification
    1. Verify the customer concern is with the evaporative emission (EVAP) system. 2. Visually inspect for the following obvious signs of mechanical damage. Visual Inspection Chart Mechanical Fuel filler cap EVAP test port ...