Ford Mustang (1999-2004) Service Manual: Transmission Draining and Filling

Material

Item Specification
DEXRON III (ATF) Transmission Fluid XT-2-QDX DEXRON III

1. Remove the drain plug and drain the transmission.

  • Position a suitable drain pan under the transmission.

Transmission Draining and Filling

2. Clean and install the drain plug.

3. NOTE: Before removing, clean the area around the filler plug.

Remove the filler plug.

Transmission Draining and Filling

4. Using a suitable oil suction gun, fill the transmission to the correct level with the specified fluid.

  • Transmission capacity is 3.9 liters (4.1 quarts).

Transmission Draining and Filling

5. Install the filler plug.

    Manual Transmission
    The T56 six-speed manual transmission features the following: six forward speeds and one reverse speed. forward gears are synchronized and helical cut. a reverse gear operates through a constant-m ...

    Transmission (Removal)
    1. Remove the gearshift lever knob. 2. Remove the console panel gearshift plate. Disconnect the cigar lighter electrical connector, then lift the gearshift lever boot over the gearshift lever. 3. ...

    Other materials:

    Apply Components
    There are eight apply components used to drive or hold the planetary gearset components. Band-Overdrive   1. The overdrive band holds the reverse clutch drum stationary in fourth gear and manual 2. This action causes the reverse sun gear to be h ...

    Pinpoint Test M: DTC B1891 - Air Bag Tone Warning Indicator Circuit Shorted to Battery or Ignition
    Normal Operation The restraints control module (RCM) monitors its connection to the generic electronic module (GEM) at pin 10. This connection is used to signal a chime if the air bag indicator is inoperative and another SRS fault exists. If the RC ...

    Sensor - Front
    Removal 1. Remove the wheel and tire assembly. 2. Remove the inner fender splash shield. 1. Remove the inner fender splash shield push pins. 2. Remove the inner fender splash shield screw. 3. Remove the inner fender splash shield. 3. Remove the front ...