Ford Mustang (1999-2004) Service Manual: Manual Transaxle/Transmission - T56
General Specifications
Torque Specifications
- Manual Transmission
- Transmission Draining and Filling
- Transmission (Removal)
- Transmission (Disassembly)
- Input Shaft and Bearing
- Output Shaft
- Countershaft
- Synchronizers
- Gearshift Rail and Fork
- Extension Housing
- Transmission Case
- Transmission (Assembly)
- Transmission (Installation)
Manual Transmission
The T56 six-speed manual transmission features the following:
six forward speeds and one reverse speed.
forward gears are synchronized and helical cut.
a reverse gear operates through a constant-m ...
Other materials:
Installation
1. NOTE: This procedure applies to both the LH and RH halfshafts.
Install a new driveshaft bearing retainer circlip.
2. Remove the special tool.
3. CAUTION: Differential seal damage will occur if installing the
halfshaft without the
special tool installed. ...
Latch - Front Seat Backrest
Removal
NOTE: The power seat backrest adjuster assembly must be installed as a
new unit. Repair of the
power seat backrest adjuster assembly components is not acceptable and
should not be attempted.
1. Remove the two screws and the seat backrest latch ...
Module
Removal
1. Remove the hydraulic control unit (HCU). Refer to Hydraulic Control Unit .
2. Remove the pump motor electrical connector.
3. Remove the anti-lock-brake control module screws.
4. Remove the anti-lock-brake control module from the HCU.
Installation
...
