Ford Mustang (1999-2004) Service Manual: Trim Panel - Upper Quarter
Special Tool(s)
![]() |
Safety Belt Bolt Bit 501-010 (T77L-2100-A) |
Removal and Installation
1. Remove the rear seat cushion.
2. Using the special tool, remove the rear safety belt anchor bolt.

3. Remove the screw and the coat hook.

4. Open the front safety belt guide bolt cover.

5. Using the special tool, remove the front safety belt guide bolt.

6. Remove the upper quarter trim panel.

7. To install, reverse the removal procedure.
Trim Panel - Quarter, Convertible
Special Tool(s)
Safety Belt Bolt Bit
501-010 (T77L-2100-A)
Removal and Installation
1. Lower the convertible top to the full down position.
2. Remove the rear seat cushion.
3. ...
Trim Panel - Package Tray
Special Tool(s)
Torx Bit, Safety Belt Bolt
501-010 (T77L-2100-A)
Removal and Installation
1. Remove the screw and the coat hook.
2. NOTE: Inspect the shoulder safety belt guide cov ...
Other materials:
Exterior mirrors
Power Exterior Mirrors
WARNING: Do not adjust the mirror while your vehicle is in
motion.
A. Left mirror
B. Off
C. Right mirror
To adjust your mirrors:
1. Select the mirror you want to adjust.
2. Move the control in the direction you want to tilt the mirror.
...
Installation
1. CAUTION: To prevent refrigerant system contamination, do not allow
dirt or other
foreign materials to enter the A/C compressor.
Clean the A/C compressor nose area.
2. Place the shaft seal on the special tool. Lubricate the shaft seal and the
special tool ...
Disc and Pressure Plate - 3.8L and 4.6L (2V) Engines
Special Tool(s)
Clutch Aligner
308-020 (T74P-7137-K)
Material
Item
Specification
Premium Long Life Grease
XG-1-C
ESA-M1C75-B
1. Remove the transmission.
2. CAUTION: Loosen the bolts evenly to prevent clutch pressure plate
...

