Ford Mustang (1999-2004) Service Manual: Warning Indicator Bulb
Removal and Installation
1. Remove the instrument cluster. Refer to Instrument Cluster in this section.
2. Remove the necessary instrument cluster bulbs by rotating one quarter turn counterclockwise.
3. To install, reverse the removal procedure.
Instrument Cluster Lens
Removal and Installation
1. Remove the instrument cluster. Refer to Instrument Cluster in this section.
2. Remove the screws and remove the instrument cluster lens.
3. To install, reverse the removal procedure.
Instrument Cluster (Removal and Installation)
Removal and Installation
All vehicles
1. CAUTION: Electronic modules are sensitive to electrical
charges. If exposed to
these charges, damage may result.
Disconnect the battery ground cabl ...
Horn
Torque Specifications
Horn
The horn system consists of the following:
dual horns (one high-pitched, one low-pitched)
horn switch (located underneath the driver side air bag module
[043 ...
Other materials:
Transmission Electronic Control System
The powertrain control module (PCM) and its input/output network
control the following transmission
operations:
Shift timing
Line pressure (shift feel)
Torque converter clutch
The transmission control is separate from the engine control s ...
Installation
1. Install the upper arm and bushing to the mounting bracket.
1. Position the arm and bushing.
2. Install a new nut and bolt. Do not tighten at this time.
2. Connect the upper arm and bushing to the axle.
1. Position the arm and bushing.
2. Install a ...
Retractor - Rear Seat Safety Belt, Coupe
Special Tool(s)
Torx Bit, Safety Belt Bolt
501-010 (T77L-2100-A)
Removal
1. Remove the quarter trim panel (31012) and the angel wing trim. For
additional information, refer
to Section.
2. Using the special tool, remove the D-ring bolt.
3. U ...
