Ford Mustang (1999-2004) Service Manual: Engine Ignition - 3.8L
General Specifications
Torque Specifications
Starter Motor - 4.6L
Removal
WARNING: When servicing starter motor (11002) or carrying out other
underhood work in
the vicinity of the starter motor, be aware that the heavy gauge battery
input lead at the starter
...
Engine Ignition (Description and Operation)
The ignition coil (12029), which is mounted on the upper intake manifold, can
be described as a coil
pack containing three separate coil units. Each coil unit is individually
controlled by the power ...
Other materials:
Inspection and Verification
1. Road test.
Verify the customer's concern by performing a road test on a smooth
road.
2. Inspect tires.
Check the tire pressure with all normal loads in the vehicle and the
tires cold. For
additional information, refer to the vehicle certification ...
Differential Pressure Feedback Exhaust Gas Recirculation
(EGR) System
Removal and Installation
1. NOTE: The 4.6L (2V) is shown. The 4.6L (4V) and 3.8L are
similar.
NOTE: Bolts may be used in place of nuts on some applications.
Remove the differential pressure feedback EGR.
1. Disconnect the connector.
2. Remove the ...
Torque Converter Leak Check
Special Tool(s)
Leak Tester, Torque Converter
307-421
1. Clean the outside surface of the torque converter.
2. Install the special tool into the converter hub.
3. WARNING: Always follow correct safety procedures while using press.
Failure t ...
