Ford Mustang (1999-2004) Service Manual: Hydraulic Lash Adjusters
Removal
1. Remove the roller followers. For additional information, refer to Roller Followers in this section.
2. Remove the 16 hydraulic lash adjusters.
3. Inspect the roller followers. For additional information, refer to Section.
Installation
1. To install, reverse the removal procedure.
Installation
1. Using the special tools, install the new intake valve stem seals. 2. Using the special tools, install the new exhaust valve stem seals. 3. Install the Valve Spring Compressor Spacer between the ...Roller Followers
Special Tool(s) Compressor, Valve Spring 303-452 (T93P-6565-AR) Removal and Installation 1. Remove the LH and RH valve cover. For additional information, refer to Valve Cover LH and ...Other materials:
Removal
CAUTION: Since the engine is not free-wheeling, timing procedures must
be followed
exactly or piston and valve damage can occur.
1. Remove the engine front cover. For additional information, refer to Engine
Front Cover in this
section.
2. Remove the cranksh ...
Floor mats
WARNING: Always use floor mats that are designed to fit the
footwell of your vehicle. Only use floor mats that leave the pedal
area unobstructed. Only use floor mats that are firmly secured to
retention posts so that they cannot slip out of position and inter ...
Spark Plugs
Special Tool(s)
Remover, Spark Plug Wire
303-106 (T74P-6666A)
Material
Item
Specification
Silicone Brake Caliper Grease
and Dielectric Compound
D7AZ-19A331-A or equivalent
ESE-M1C171-
A
Removal and Installation
CAUTION: ...