Ford Mustang (1999-2004) Service Manual: Parking Brake and Actuation
Torque Specifications

- Parking Brake (Description and Operation)
- Parking Brake (Diagnosis and Testing)
- Parking Brake Cable Tension Release
- Parking Brake Control
- Cable and Conduit - Front
- Cable and Conduit
Caliper (Disassembly and Assembly)
Special Tool(s)
Rear Caliper Piston Adjuster
206-026 (T87P-2588-A)
Rear Caliper Spring
Compressor Set
206-S027 (T87P-2588-B)
Disassembly
1. Remove the rear disc brake calip ...
Parking Brake (Description and Operation)
The parking brake system is cable-actuated and controlled by an independent
hand-operated parking
brake control (2780). To apply parking brake, pull parking brake control upward
as far as ...
Other materials:
Installation
1. Install a new upper intake manifold gasket.
2. NOTE: Refer to the location note made during removal and make sure
the bolts are installed in
the correct locations.
Install the upper intake manifold. Tighten the bolts in two stages in the
sequence shown ...
Inspection and Assembly Requirements - Following an
A/C
Compressor Failure
CAUTION: To prevent refrigerant system contamination and possible
failure of the new
A/C compressor, carry out the following procedures.
1. NOTE: A dirty A/C evaporator core orifice or a condenser to
evaporator tube containing black
refrigerant oil and parti ...
Electronic Engine Controls (Description and Operation)
The electronic engine controls consist of the following:
powertrain control module (PCM)
throttle position (TP) sensor
idle air control (IAC) valve
engine coolant temperature (ECT) sensor
cylinder head temperature sensor
camshaft position ...
