Ford Mustang (1999-2004) Service Manual: Crankshaft Front Seal
Special Tool(s)
 |
Installer, Front Cover Oil Seal 303-335 (T88T-6701-A) |
 |
Installer, Crankshaft Front Oil Seal 303-474 (T94P-6701-AH) |
 |
Remover, Oil Seal 303-409 (T92C-6700-CH) |
Material
Removal
1. Remove the crankshaft pulley. For additional information, refer to Crankshaft Pulley in this section.
2. Using the special tool, remove and discard the crankshaft front seal.
Installation
1. NOTE: Lubricate the crankshaft front seal with clean engine oil before assembly.
Using the special tool, install the crankshaft front seal.
2. Install the crankshaft pulley. For additional information, refer to Crankshaft Pulley in this section.
Crankshaft Pulley
Special Tool(s)
Remover, Crankshaft Vibration
Damper
303-009 (T58P-6316-D)
Remover, Crankshaft Vibration
Damper
303-176 (T82L-6316-B)
Installer, Crankshaft
Damper/C ...
Engine Front Cover
Material
...
Other materials:
Axle Assembly
Removal and Installation
1. CAUTION: The vehicle must be on level ground and at curb height.
Mark the rear shock absorbers relative to their protective sleeve.
During installation, raise the suspension to this reference mark before
tightening the
suspens ...
Camshaft End Play - Push Rod Engines
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C) or
equivalent
1. Remove the valve tappets. Refer to the appropriate section in Group 303
for the procedure.
2. Use a Dial Indicator Gauge with Holding Fixture ...
Handle - Interior Door
Removal
1. Remove the door trim panel (23942). For additional information,
refer to Section.
2. Remove the rivet.
3. Remove the cable clip.
4. Release the cable housing from the interior handle.
5. Release the actuating cable from the interior ha ...
