Ford Mustang (1999-2004) Service Manual: Engine Front Cover

Crankshaft Front Seal

Special Tool(s) Installer, Front Cover Oil Seal 303-335 (T88T-6701-A) Installer, Crankshaft Front Oil Seal 303-474 (T94P-6701-AH) Remover, Oil Seal 303-409 (T92C-6700 ...

Removal

1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Drain the engine cooling system. For additional information, refer to Section . 3. Remove the crankshaf ...

Other materials:

Installation
1. NOTE: Inspect the spring insulators for wear or damage. Install new spring insulators if necessary. Make sure the spring insulators are correctly installed on the springs. 2. Install the springs. 1. Position the springs. 2. Raise the subframe using ...

System Bleeding
1. If required, remove the hydraulic system from the vehicle. Refer to Hydraulic System, Lift Cylinder and Motor in this section. 2. Remove the fill plug at the end of the hydraulic pump. 3. Fill the pump with Mercon Multi-Purpose Automatic Transmiss ...

Electronic Engine Controls - Cobra
Most of the Cobra engine electronic controls are similar to that of the non-supercharged 4.6L (2V) engine. These components are as follows: Crankshaft position (CKP) sensor Throttle position (TP) sensor Idle air control (IAC) valve Mass air ...