Ford Mustang (1999-2004) Service Manual: Engine Front Cover

Material

Item Specification
Silicone Gasket and Sealant F7AZ-19554-EA or equivalent WSE-M4G323- A4
Super Premium SAE 5W-20 Motor Oil XO-5W20-QSP or equivalent WSS-M2C153-H
Crankshaft Front Oil Seal
Special Tool(s) Crankshaft Seal Installer/Aligner 303-335 (T88T-6701-A) Front Cover Seal Remover 303-107 (T74P-6700-A) Crankshaft Seal Installer 303-635 ...

Removal
1. Remove the nuts and position the radio ignition interference capacitors aside. 2. Remove the valve covers. For additional information, refer to Valve Cover RH and Valve Cover LH in this section ...

Other materials:

Cooling System Draining, Filling and Bleeding
Material Item Specification Motorcraft Premium Gold Engine Coolant VC-7-A (in Oregon VC-7-B) (yellow color) WSS-M97B51- A1 Draining WARNING: Never remove the pressure relief cap while the engine is operating or when the cooling syst ...

Inspection and Repair After a Supplemental Restraint System (SRS) Deployment
WARNING: If the supplemental restraint system (SRS) is being serviced, the system must be deactivated and restraint system diagnostic tools must be installed. Refer to Air Bag Supplemental Restraint System (SRS) in this section. The air bag restraint system ...

Blower Motor
Removal 1. Disconnect the jumper wire. 2. Disconnect the main harness. 3. Remove the screws. 4. Separate the cover from the motor. 5. Separate the motor from the housing. 6. Disconnect the jumper from the motor. Remove the blower motor. Installa ...