Ford Mustang (1999-2004) Service Manual: Engine Ignition - 4.6L (4V)

General Specifications

General Specifications

Torque Specifications

Torque Specifications

Spark Plug
Removal 1. Remove the ignition coil on plug. For additional information, refer to Ignition Coil-Coil On Plug in this section. 2. NOTE: Use compressed air to remove any foreign material from the ...

Engine Ignition (Description and Operation)
Eight separate ignition coils: are controlled by the powertrain control module (PCM). are mounted directly above each spark plug. are controlled by the powertrain control module for correct fi ...

Other materials:

Muffler - 4.6L (2V)
Removal and Installation 1. Use a jack to support and lower the rear axle. 2. Remove the upper arm-to-differential bolt. 3. Remove the nut and bolt, and disconnect the rear shock absorbers (18124) from the axle housing. Discard the nut. 4. Lower the r ...

Turn Signal and Hazard Lamps
Refer to Wiring Diagrams Cell 90 , Turn/Stop/Hazard Lamps for schematic and connector information. Special Tool(s) 73 III Automotive Meter 105-R0057 or equivalent Inspection and Verification 1. Verify the customer concern. 2. Visually ins ...

Front Subframe - 3.8L Engine
Special Tool(s) 3-Bar Engine Support Kit 303-F072 Lifting Bracket Set, Engine 303-D095 (D94L-6001-A) (014- 00792) Removal and Installation All vehicles 1. Remove the steering gear. For additional information, refer to Section. ...