Ford Mustang (1999-2004) Service Manual: Hydraulic System, Lift Cylinder and Motor

Stay Pad - Convertible Top
Removal 1. Remove the convertible top material. For additional information, refer to Convertible Top Material in this section. 2. Remove the rear window glass. For additional information, refer to ...

Removal
NOTE: The convertible top hydraulic components are removed from the vehicle as an assembly. The hydraulic components are individually repaired and the system must be bled before being installed into ...

Other materials:

Installation
1. Inspect the pinion flange seal journal for rust, nicks, and scratches prior to installing the flange. Polish the seal journal with fine crocus cloth, if necessary. 2. Lubricate the pinion flange splines. Use SAE 80W-90 Premium Rear Axle Lubricant XY-80 ...

Clutch Pedal - Quadrant and Pawl Assembly
Removal 1. Disconnect the battery ground cable (14301). 2. Loosen the nut from inside the engine compartment. 3. Loosen the nuts from inside the vehicle. 4. Loosen the screw. 5. Disconnect the brake pedal position (BPP) switch electrical connector. ...

Cable Adjustment
1. NOTE: Make sure that the range selector lever is tight against the rearward overdrive stop. Place the transmission range selector lever in the overdrive position. 2. Raise and support the vehicle. For additional information, refer to Section. ...