Ford Mustang (1999-2004) Service Manual: Intake Manifold - Lower

Installation

1. Install the upper intake manifold gasket. 2. Install the intake manifold and bolts in the sequence shown. 3. Install the PCV valve-to-intake manifold tube. 4. Connect the vacuum hoses and ...

Removal

1. Remove the upper intake manifold. For additional information, refer to Intake Manifold-Upper in this section. 2. Disconnect the fuel line. For additional information, refer to Section. 3. Remove ...

Other materials:

Seal
Special Tool(s) Installer, Transmission Extension Housing Oil Seal 308-227 (T94P-7657-A) Slide Hammer 100-001 (T50T-100-A) Remover, Bushing 307-001 (TOOL-1175-AC) or Equivalent Removal 1. With the vehicle in NEU ...

Contaminated Refrigerant Handling
1. CAUTION: If contaminated refrigerant is detected, DO NOT recover the refrigerant into your recovery/recycling equipment. Recover the contaminated refrigerant using suitable recovery-only equipment designed for capturing and storing contaminated refrigeran ...

Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear
General Specifications a: In-vehicle repair refill capacities are determined by filling the rear axle with the specified lubricant to 6.4-14.3-mm (1/4-9/16-in) below the bottom of the fill hole. Torque Specifications ...