Ford Mustang (1999-2004) Service Manual: Module Communications Network
General Specifications
Communications Network
Module Communications Network
Communications Network (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 14 , Multiplex Communication Network for
schematic and connector
information.
Special Tool(s)
73 Digital Multimeter or
equivalent
105-R0051
...
Other materials:
Engine Coolant Temperature (ECT) Sensor - Mach I
Material
Item
Specification
Pipe Sealant with Teflon
D8AZ-19554-A
WSK-M2G350-A2
Removal and Installation
1. Remove the air intake scoop. For additional information, refer to
Section.
2. Partially drain the engine cooling system. For ...
Installation
1. NOTE: LH shown; RH similar.
Install the camshafts.
Lubricate the camshafts with clean engine oil.
2. Install the camshaft bearing cap assemblies and tighten the bolts in the
sequence shown.
3. Install the bolts.
4. CAUTION: Timing marks must be a ...
Master Cylinder Priming - 4.6L
1. CAUTION: Use only bleed screws on the engine side of the
brake master cylinder
(2140). The hydro-boost bleed screw, located near the dash on the
hydro-booster
casting, is for the booster cavity filled with power steering fluid, not
brake fluid. ...
