Ford Mustang (1999-2004) Service Manual: Output Shaft Speed (OSS) Sensor
Removal and Installation
1. With the vehicle in NEUTRAL, raise and support the vehicle.
2. Disconnect the electrical connector.
3. Remove the output shaft speed (OSS) sensor.
4. To install, reverse the removal procedure.
Transmission (Removal)
1. Disconnect the battery ground cable. For additional information, refer to
Section.
2. Remove the gearshift lever knob.
3. Remove the console panel gearshift plate. Lift the gearshift lever boot ...
Other materials:
Installation
1. Make sure the anti-rattle spring is correctly positioned in the
caliper.
2. CAUTION: Make sure guide pin boots are correctly seated or damage to
guide pins
can occur.
Install the disc brake caliper.
1. Hold the guide pins stationary.
2. Inst ...
Oil Filter Adapter
Removal
1. Drain the cooling system. For additional information, refer to Section.
2. Disconnect the lower radiator hose.
3. Raise the vehicle. For additional information, refer to Section.
4. Drain the engine oil.
5. Remove the oil filter adapter.
1. ...
Lamp Assembly - Fog Lamp (GT)
Removal
1. Raise and support the vehicle.
2. Remove the screw.
3. Partially lower the vehicle and remove the fog lamp assembly.
1. Disconnect the electrical connector.
2. Remove the two screws.
3. Remove the fog lamp assembly and replace the bul ...
