Ford Mustang (1999-2004) Service Manual: Removal
1. Raise and support the vehicle.
2. Remove the rear wheel and tire assemblies.
3. CAUTION: Remove the rear brake calipers to prevent drag during the drive pinion bearing preload adjustment.
CAUTION: Do not allow the calipers to hang from the brake hoses.
Remove the rear brake caliper and support bracket from the knuckle as an assembly. Wire the caliper and support bracket assembly out of the way.
4. CAUTION: Index-mark the driveshaft flange and pinion flange (4851) to maintain initial balance during installation.
CAUTION: The driveshaft centering socket yoke fits tightly on the pinion flange pilot. Never hammer on the driveshaft or any of its components to disconnect the yoke from the flange. Pry only in the area shown, with a suitable tool, to disconnect the yoke from the flange.
Disconnect and position the driveshaft out of the way.
5. Install an Nm (inch/pound) torque wrench on the nut and record the torque necessary to maintain rotation of the drive pinion gear through several revolutions.
6. CAUTION: After removing the nut, discard it. Use a new nut for installation.
Use the special tool to hold the pinion flange while removing the nut.
7. Index-mark the pinion flange and drive pinion gear stem to maintain initial balance during installation.
8. Using the special tool, remove the pinion flange.
Drive Pinion Flange and Drive Pinion Seal
Special Tool(s) 2-Jaw Puller 205-D072 (D97L-4221-A) or equivalent Holding Fixture, Drive Pinion Flange 205-126 (T78P-4851-A) Installer, Drive Pinion Flange 205-002 ...Installation
1. Inspect the pinion flange seal journal for rust, nicks, and scratches prior to installing the flange. Polish the seal journal with fine crocus cloth, if necessary. 2. Lubricate the pinion flange ...Other materials:
Supply Manifold
Removal
WARNING: Do not smoke or carry lighted tobacco or open flame of any
type when
working on or near any fuel related components. Highly flammable mixtures are
always present
and can ignite. Failure to follow these instructions can result in personal
in ...
Crankshaft Rear Seal
Special Tool(s)
Impact Slide Hammer
100-001 (T50T-100-A)
Remover, Crankshaft Rear
Seal
303-519 (T95P-6701-EH)
Replacer, Rear Crankshaft
Seal
303-516 (T95P-6701-BH)
Spacer, Rear Crank Seal
Replacer
30 ...
Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear
General Specifications
a: In-vehicle repair refill capacities are determined by filling the rear axle
with the specified lubricant to
6.4-14.3-mm (1/4-9/16-in) below the bottom of the fill hole.
Torque Specifications
...