Ford Mustang (1999-2004) Service Manual: Reverse Clutch
Special Tool(s)
 |
Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) |
 |
Compressor, Clutch Spring 307-015 (T65L-77515-A) |
 |
Protector, Transmission Reverse Clutch Outer Fluid Seal 307-424 |
 |
Protector, Transmission Reverse Clutch Inner Fluid Seal 307-425 |
 |
Compressor, Clutch Spring 307-086 (T80L-77405-A) |
Material
| Item | Specification |
| MERCON V Automatic Transmission Fluid XT-5-QM, XT-5-DM |
Reverse Clutch Disassembled View
Intermediate One-Way Clutch
Intermediate Clutch Cylinder Disassembled View
Disassembly
1. NOTE: One tab that locks the reverse clutch drum into the reverse
sun shell may be removed.
This is done for balancing purpos ...
Disassembly
1. Inspect the clutch cylinder thrust surfaces, piston bore and clutch plate
serrations for scores or
burrs. Minor scores or burrs may be removed with a crocus cloth. Install a new
clutch cylinder i ...
Other materials:
Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive
discs or other
abrasive means to clean the sealing surfaces. These tools cause scratches and
gouges
which make leak paths. Use a plastic scraping tool to remove all traces of old
sealant.
...
Axle Housing
Removal and Installation
1. CAUTION: The vehicle must be on level ground and at curb height.
Mark the rear shock absorbers relative to their protective sleeve.
During installation, raise the suspension to this reference mark
before tightening the
s ...
Caliper (DISASSEMBLY AND ASSEMBLY)
Disassembly
1. Remove the disc brake caliper (2B120). For additional information,
refer to Caliper in this
section.
2. Drain the remaining brake fluid from disc brake caliper.
3. Apply low air pressure to the fluid port in the disc brake caliper.
...
