Ford Mustang (1999-2004) Service Manual: Synchronizers
Disassembly and Assembly
NOTE: This procedure applies to all synchronizer assemblies.
1. Scribe an alignment mark on the sliding sleeve and the hub for assembly reference.
2. Remove the sliding sleeve, then remove the synchronizer struts and the springs.
3. Install the synchronizer struts and the springs.
4. CAUTION: Match the alignment marks made during disassembly. The sleeve and the hub have an extremely close fit. Hold the sleeve and hub square to prevent jamming. Do not force the sleeve onto the hub.
Install the sliding sleeve.
Countershaft Bearing
Special Tool(s) Remover, Drive Pinion Bearing Cone 205-D002 (D79L-4621-A) or equivalent Installer, Drive Pinion Bearing Cone 205-011 (T57L-4621-B) Disassembly and A ...Gearshift Rail Bushing
Special Tool(s) Universal Puller Set 303-DS005 (D80L-100-A) or equivalent Installer, Shift Rail Bushing 308-244 (T96P-7025-F) Slide Hammer 100-001 (T50T-100- ...Other materials:
General information
Note: Occasional brake noise is normal. If a metal-to-metal,
continuous
grinding or continuous squeal sound is present, the brake linings may be
worn out. Have them inspected by an authorized dealer. If your vehicle
has continuous vibration or shudder in the ...
Door - Air Inlet Duct
Removal
1. Remove the evaporator core housing. For additional information, refer to
Section.
2. Disconnect the vacuum line.
3. Remove the screws and remove the duct.
Installation
1. To install, reverse the removal procedure.
...
Climate Control System (Description and Operation)
WARNING: To avoid accidental deployment and possible injury, the air
bag system
backup power supply must be depleted before repairing any climate control
components. To
deplete the backup power supply, disconnect the battery ground cable and wait
one minute ...