Ford Mustang (1999-2004) Service Manual: Transaxle/Transmission Cooling
General Specifications
Torque Specifications
Transmission (INSTALLATION)
Special Tool(s)
Retainer, Torque Converter
307-346 (T97T-7902-A)
Material
Item
Specification
Multi-Purpose Grease
D0AZ-19584-AA
ESB-M1C93-
B
MERCON V Automatic ...
Transmission Cooling - Integral
This vehicle with an automatic transmission is equipped with an integral
transmission fluid cooler. The
cooler is contained inside of the radiator outlet tank and cannot be serviced
separately. The ...
Other materials:
Installation
All vehicles
CAUTION: After installing the urethane installed windshield,
the vehicle should not be
driven until the urethane adhesive has cured. The curing time at
temperatures above 13C (55
F) and relative humidity above 50% is 12-24 hours (Refer ...
Pressure Relief
Special Tool(s)
Fuel Pressure Gauge
310-012 (T80L-9974-B)
WARNING: Do not smoke or carry lighted tobacco or open flame of any
type when
working on or near any fuel-related components. Highly flammable mixtures are
always present
and may be ig ...
Removal
1. Use a suitable suction device to lower the brake fluid level in
the master cylinder reservoir.
2. Raise and support the vehicle.
3. Remove the wheel and tire assembly.
4. Inspect the pads for wear or contamination, install new if worn to ...
