Ford Mustang (1999-2004) Service Manual: Wheel Hub - Cobra
Special Tool(s)
 |
2-3 Jaw Puller 205-D026 (D80L-1013-A) or Equivalent |
 |
Driver 205-199 (T83T-3132-A1) |
 |
Front Hub Remover Replacer 204-069 (T81P-1104-C) |
 |
Hub Bearing Remover 204-081 (T83P-1104-AH2) |
 |
Hub Dust Seal Replacer 205-289 (T89P-1249-A) |
 |
Rear Hub Remover 205-287 (T89P-1225-AH) |
 |
Receiving Cup 205-286 (T89P-1104-A) |
 |
Step Plate Adapter 205-D016 (D80L-630-5) or Equivalent |
 |
Step Plate Adapter Set 205-DS011 (D80L-630-A) or Equivalent |
Rear Suspension (Description and Operation)
Item
Part Number
Description
1
18125
Rear shock absorber
2
-
Rear axle driveline vibration damper
3
5A649
Rear lower suspension arm and bushing (common ...
Removal
CAUTION: Suspension fasteners are critical parts because they affect
performance of vital
components and systems and their failure can result in major service expense. A
new part with
the same part ...
Other materials:
Accelerator Cable - 3.8L
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and
shaft arm.
2. Remove the bolts retaining the accelerator cable to the dash panel.
3. Disconnect the accelerator cable from the throttle body by rotating ...
Throttle Position (TP) Sensor
Removal
NOTE: The 3.8L engine is shown; the 4.6L (2V) is similar.
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the throttle position (TP) sensor.
Disconnect the connector.
Remove the screws, ...
Resistor
Removal
1. Disconnect the connector.
2. Remove the screws.
3. Remove the resistor.
Installation
1. To install, reverse the removal procedure. ...
