Ford Mustang (1999-2004) Service Manual: Window Glass - Quarter, Convertible

Removal

1. Remove the quarter trim panel. For additional information, refer to Section.

2. Disconnect the connectors and remove the screw.

Window Glass - Quarter, Convertible

3. Remove the screw.

Window Glass - Quarter, Convertible

4. Remove the screw and the speaker.

Window Glass - Quarter, Convertible

5. Disconnect the electrical connector.

Window Glass - Quarter, Convertible

6. Remove the watershield.

Window Glass - Quarter, Convertible

7. Remove the interior weatherstrip.

Window Glass - Quarter, Convertible

8. Remove the bolt.

Window Glass - Quarter, Convertible

9. Remove the bolts and the glass.

Window Glass - Quarter, Convertible

Installation

1. To install, reverse the removal procedure.

    Window Glass - Quarter
    Removal 1. Remove the quarter trim panel. For additional information, refer to Section. 2. Remove the roof side trim moulding. For additional information, refer to Section. 3. Remove the ...

    Motor - Window Regulator
    Removal 1. Remove the door trim panel. For additional information, refer to Section. 2. Remove the screws and the speaker. 3. Disconnect the electrical connector. 4. Remove the screws and ...

    Other materials:

    Touchscreen climate controls
    Press the CLIMATE hard button to access your climate control features. Depending on your vehicle line and option package, your climate screen may look different from the screen shown here. Climate Control Voice Commands If you are not viewing the climate co ...

    Cruise Control
    PRINCIPLES OF OPERATION Cruise control lets you maintain a set speed without keeping your foot on the accelerator pedal. USING CRUISE CONTROL WARNING: Do not use cruise control in heavy traffic, on winding roads or when the road surface is slippery. This coul ...

    Axle Housing Casting Porosity (Holes in Casting) Repair
    CAUTION: To keep the axle's sound characteristics, do not disassemble the carrier. NOTE: Casting porosity is a condition where occasionally gas bubbles will form during the casting process leaving small pockets in the metal that will cause the axle housing t ...