Ford Mustang (1999-2004) Service Manual: Glass, Frames and Mechanisms
WINDOW REGULATOR ELECTRIC DRIVE CURRENT DRAW
General Specifications
Torque Specifications
- Glass, Frames and Mechanisms (Description and Operation)
- Glass, Frames and Mechanisms (Diagnosis and Testing)
- Heated Window Grid Wire Repair
- Lead Terminal Repair
- Door Window Glass Adjustment - Height Stop Adjustment
- Switch - Window Regulator Control
- Rear Window Glass
- Window Glass - Door
- Window Glass - Quarter
- Window Glass - Quarter, Convertible
- Motor - Window Regulator
- Window Regulator - Power
- Windshield Glass
Front Seat Backrest
Disassembly and Assembly
All vehicles
1. Remove the front seat backrest. For additional information, refer to
Front Seat Backrest in this
section.
2. Remove the front seat backrest head restrai ...
Glass, Frames and Mechanisms (Description and Operation)
Component Location
Windshield Glass
The windshield exterior mouldings are installed with the windshield
glass. The windshield exterior
mouldings cannot be replaced without removal of the ...
Other materials:
Rear Suspension
Torque Specifications
WARNING: All vehicles are equipped with gas pressurized shock absorbers
which will
extend unassisted. Do not apply heat or flame to the shock absorbers during
removal or
component servicing. Failure to follow these instructions can re ...
Evaporative Emission Repair Verification Drive Cycle
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052, or equivalent scan
tool
Drive Cycle Recommendations
NOTE: The following procedure is designed to execute and
complete the evap ...
Master Cylinder Priming - 4.6L
1. CAUTION: Use only bleed screws on the engine side of the
brake master cylinder
(2140). The hydro-boost bleed screw, located near the dash on the
hydro-booster
casting, is for the booster cavity filled with power steering fluid, not
brake fluid. ...
