Ford Mustang (1999-2004) Service Manual: Wiring Harness

Fuel Injectors

Removal WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and can ignite. Fai ...

Removal

WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and can ignite. Failure to ...

Other materials:

Suction Accumulator to Compressor Line - 4.6L
Material Item Specification PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) WSH-M1C231- B Removal and Installation NOTE: Installation of a new suction accumulator is not required when repairing the ...

Installation
1. Install the bearing. 1. Position the knuckle on the press. 2. Using the appropriate step plate adapter, press the bearing into the knuckle until the bearing clears the snap ring groove and bottoms out in the bore. 2. Install the snap ring. 3. CA ...

Removal
1. Disconnect the battery negative cable. 2. Drain the engine cooling system. 3. Remove the LH exhaust manifold. For additional information, refer to Exhaust Manifold-LH in this section. 4. Remove the lower intake manifold. For additional informatio ...