Ford Mustang (1999-2004) Service Manual: Battery and Charging System
- Charging System - General Information
- Battery, Mounting and Cables
- Battery and Cables
- Battery (Diagnosis and Testing)
- Battery Disconnect
- Battery (Removal and Installation)
- Battery Tray
- Battery Cables
- Generator and Regulator
Switch - Key-In-Ignition Warning
Removal
1. Remove the ignition switch lock cylinder.
1. Insert the ignition key and turn to the RUN position.
2. Insert a punch in the access hole of the steering column and
press the ...
Charging System - General Information
General Specifications
...
Other materials:
Dowels - Flywheel
Removal
1. NOTE: Take care not to damage the flywheel dowel holes or the
surface areas around the
flywheel dowel during removal.
Remove the flywheel dowels by using a drift pin where the flywheel dowel is
installed in an open
hole and a pair of lockin ...
Clutch Pedal - Quadrant and Pawl Assembly
Removal
1. Disconnect the battery ground cable (14301).
2. Loosen the nut from inside the engine compartment.
3. Loosen the nuts from inside the vehicle.
4. Loosen the screw.
5. Disconnect the brake pedal position (BPP) switch electrical connector.
...
Cylinder Head LH
Special Tool(s)
Remover, Power Steering
Pump Pulley
211-016 (T69L-10300-B)
Installer, Power Steering Pump
Pulley
211-009
Material
...
