Ford Mustang (1999-2004) Service Manual: Exterior Lighting
Torque Specifications

Exterior Lighting
The exterior lighting system consists of the following components:
- headlamps (13008)
- parking lamps
- rear lamps (13404)
- high mounted stoplamp
- license lamps
- front turn lamps
- reversing lamps
- fog lamps (if equipped)
- headlamp switch (11654)
- fog lamp switch (if equipped)
- brake pedal position (BPP) switch (13480)
- multifunction switch (13K359)
- digital transmission range (DTR) sensor (A/T)
- reversing lamp switch (M/T)
- electronic flasher
- fog lamp relays (if equipped)
- Headlamps
- Stoplamps
- Turn Signal and Hazard Lamps
- Parking, Rear and License Lamps
- Fog Lamps
- Reversing Lamps
- Headlamp Adjustment
- Bulb - Headlamp
- Lamp Assembly - Headlamp
- Lamp Assembly - Fog Lamp (GT)
- Lamp Assembly - Rear
- Lamp Switch - Headlamp
- Lamp Switch - Brake Pedal Position (BPP)
Lighting
...
Headlamps
Refer to Wiring Diagrams Cell 85 , Headlamps for schematic and
connector information.
Special Tool(s)
73III Automotive Meter or
equivalent
105-R0057
Inspection and Verification
...
Other materials:
Crankshaft Position (CKP) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the crankshaft position (CKP) sensor.
Disconnect the connector.
Remove the bolts and the sensor.
Installation
1. To install, reverse ...
Assembly
1. NOTE: Universal joint service kits are to be installed as complete
assemblies only. Do not mix
components from other U-joint kits.
Install the bearing cup.
1. Start a new bearing cup into the driveshaft yoke.
Check the needle bearings for correct po ...
Connecting Rod - Bearing Journal Clearance
Special Tool(s)
Plastigage
303-D031 (D81L-6002-B) or
equivalent
NOTE: The crankshaft connecting rod journals must be within
specifications to check the connecting
rod bearing journal clearance.
1. Remove the connecting rod bearing cap.
2. ...
