Ford Mustang (1999-2004) Service Manual: Clutch Controls
General Specifications
Torque Specifications
- Clutch Controls (Description and Operation)
- Clutch Pedal - Quadrant and Pawl Assembly
- Release Cable - Clutch
Flywheel Ring Gear
Removal
1. Remove the flywheel.
2. WARNING: This procedure should be carried out only by a
correctly equipped and
experienced acetylene torch operator. Tongs must be used or asbestos gloves
wor ...
Clutch Controls (Description and Operation)
The clutch control system engages and disengages the clutch. The clutch
control system disengages
the clutch when the clutch pedal is depressed and engages the clutch when the
clutch pe ...
Other materials:
Lumbar Assembly
Removal and Installation
All vehicles
1. Remove the front seat. For additional information, refer to Seat-Front
Power in this section.
2. Release the J-clip.
3. Remove the seat backrest latch handle knob (62762).
4. Pull the seat backrest trim cover ...
Assembly
1. NOTE: Universal joint kits are to be installed as complete
assemblies only. Do not mix
components from other U-joint kits.
Install the spider.
1. Start a new bearing cup into the driveshaft yoke.
Check the needle bearings for correct positioning.
...
Running out of fuel
Avoid running out of fuel because this situation may have an adverse
effect on powertrain components.
If you have run out of fuel:
• You may need to cycle the ignition from off to on several times after
refueling to allow the fuel system to pump the fuel fr ...
