Ford Mustang (1999-2004) Service Manual: Drive Pinion
Special Tool(s)
 |
Adapter for 205-S127 205-105 (T76P-4020-A3) |
 |
Adapter for 205-S127 205-109 (T76P-4020-A9) |
 |
Adapter for 205-S127 205-110 (T76P-4020-A10) |
 |
Adapter for 205-S127 205-111 (T76P-4020-A11) |
 |
Adapter for 205-S127 205-125 (T78P-4020-A15) |
 |
Adapter for 303-224 205-153 (T80T-4000-W) |
 |
Gauge Tube 205-D034 (D80T-4020-F49) or equivalent |
 |
Handle (Long) 205-D055 (D81L-4000-A) or equivalent |
 |
Holding Fixture, Drive Pinion Flange 205-126 (T78P-4851-A) |
 |
Installer, Drive Pinion Bearing Cone 205-005 (T53T-4621-C) |
 |
Installer, Drive Pinion Bearing Cup 205-054 (T71P-4616-A) |
 |
Installer, Drive Pinion Flange 205-002 (TOOL-4858-E) or equivalent |
 |
Installer, Drive Pinion Oil Seal 205-133 (T79P-4676-A) |
 |
Plate, Bearing/Oil Seal 205-090 (T75L-1165-B) |
 |
Protector, Drive Pinion Thread 205-460 |
 |
Puller, Bearing 205-D064 (D84L-1123-A) or equivalent |
Axle Housing Bushing
Special Tool(s)
Axle Suspension Bushing Set
204-S030 (T78P-5638-A)
Removal
CAUTION: Suspension fasteners are critical parts because they affect
performance of vital
components and sys ...
Removal
1. Remove the differential assembly from the differential housing. For
additional information, refer
to Differential Case in this section.
2. CAUTION: Record the torque necessary to maintain rotatio ...
Other materials:
Air Conditioning (A/C) Pressure Relief Valve - 4.6L
Material
Item
Specification
PAG Refrigerant Compressor
Oil (R-134a Systems)
F7AZ-19589-DA (Motorcraft YN-
12-C)
WSH-M1C231-
B
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when
repairing the ...
Valve Cover LH
Material
Item
Specification
Silicone Gasket and Sealant
F7AZ-19554-EA or equivalent
WSE-M4G323-A4
Removal and Installation
1. Position the oil level tube (6754) out of the way.
2. Disconnect the breather tube.
3. Separate the engine wir ...
Installation
1. Position the fuel charging wiring in the vehicle and attach to the rear of
the intake manifold.
2. NOTE: Make sure the locking clips are fully engaged into the bracket.
Reposition the accelerator cable and the speed control cable (if equipped)
and ...
