Ford Mustang (1999-2004) Service Manual: Driveshaft Slip Yoke

Driveshaft - Cobra

Material Item Specification Threadlock and Sealer E0AZ-19554-AA WSK-M2G351-A5 (type II) Silicone Lubricant (Aerosol) F5AZ-19553-AA ESR-M13P4-A Removal and Installatio ...

Disassembly

1. Remove the driveshaft (4602). For additional information, refer to Driveshaft in this section. 2. CAUTION: Under no circumstances is the driveshaft assembly to be clamped in the jaws of a vise o ...

Other materials:

Fuel Pump Module
Removal and Installation 1. Remove the fuel tank. For additional information, refer to Fuel Tank in this section. 2. NOTE: For installation, tighten the bolts in the sequence shown. Remove the module assembly flange bolts. 3. Clean the area around the fue ...

Idle Air Control (IAC) Valve - Cobra
Removal and Installation 1. Disconnect the idle air control (IAC) valve electrical connector. 2. Remove the bolts, the IAC valve and the gasket. 3. NOTE: Install a new gasket if necessary. To install, reverse the removal procedure. ...

Warning lamps and indicators
These indicators can alert you to a vehicle condition that may become serious enough to cause expensive repairs. Many lights will illuminate when you start your vehicle to make sure they work. If any light remains on after starting the vehicle, refer to the re ...