Ford Mustang (1999-2004) Service Manual: Driveshaft
Torque Specifications
| Description | Nm | lb-ft |
| Pinion flange bolts | 112 | 83 |
- Driveshaft (Description and Operation)
- Universal Joints
- Driveshaft (Removal and Installation)
- Driveshaft - Cobra
- Driveshaft Slip Yoke
- Universal Joint - Single Cardan, Flange Yoke
Axle Housing Casting Porosity (Holes in Casting) Repair
CAUTION: To keep the axle's sound characteristics, do not disassemble
the carrier.
NOTE: Casting porosity is a condition where occasionally gas bubbles will
form during the casting
process leaving s ...
Driveshaft (Description and Operation)
NOTE: All driveshaft assemblies are balanced. If undercoating the
vehicle, protect the driveshaft to
prevent overspray of any undercoating material.
The driveshaft has the following features ...
Other materials:
Lumbar Motor
Removal and Installation
All vehicles
1. Remove the front seat. For additional information, refer to Seat-Front
Power in this section.
2. Disconnect the power seat track electrical connector.
3. Remove the four seat track bolts.
Vehicles with standar ...
Accelerator Pedal and Shaft
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and
shaft arm.
2. Remove the accelerator pedal and shaft.
Remove the nuts.
Remove the accelerator pedal and shaft.
3. To install, reverse the removal pro ...
Drive Pinion Flange
Special Tool(s)
2-Jaw Puller
205-D072 (D97L-4221-A) or
equivalent
Holding Fixture, Drive Pinion
Flange
205-126 (T78P-4851-A)
Installer, Drive Pinion Flange
205-002 (TOOL-4858-E) or
equivalent
...
