Ford Mustang (1999-2004) Service Manual: Output Shaft
Special Tool(s)
Remover, Drive Pinion Bearing Cone 205-D002 (D79L-4621-A) or equivalent | |
Installer, Drive Pinion Bearing Cone 205-011 (T57L-4621-B) |
Input Shaft and Bearing
Special Tool(s) Remover, Driver Pinion Bearing Cone 205-D002 (D79L-4621-A) or equivalent Installer, Drive Pinion Bearing Cone 205-011 (T57L-4621-B) Remover ...Disassembly
1. Remove the retaining ring above fifth gear. 2. CAUTION: Hand tighten the special tool to prevent gear damage. CAUTION: Support the output shaft while using the press to prevent damage to the sha ...Other materials:
Rear Bumper
Removal and Installation
All vehicles
1. Remove the rear bumper cover. For additional information, refer to Rear
Bumper Cover in this
section.
2. Remove the rear bumper cover isolator.
Vehicles with 4.6L engines
3. Remove the bolts and the exhaust outlet pip ...
Accelerator Cable Bracket - 3.8L
Removal and Installation
1. Disconnect the speed control cable from the throttle body and the bracket.
For additional
information, refer to Section.
2. Disconnect the accelerator cable from the throttle body by rotating the
throttle body full open
and align ...
Instrument Cluster Replacement
When it is necessary to install a new instrument cluster, contact the
Instrument Cluster Program.
Gauge Indication Systems
Tachometer
Engine rpm information is relayed to the instrument cluster from the
powertrain control module (PCM)
over the standard ...