Ford Mustang (1999-2004) Service Manual: Pump and Intermediate Clutch Piston
Special Tool(s)
 |
Installer, Front Pump Fluid Seal 307-014 (T63L-77837-A) |
 |
Protector, Piston Seal 307-339 (T95L-77005-A) |
Pump and Intermediate Clutch Piston - Disassembled View
Assembly
1. CAUTION: Before beginning assembly, carry out and inspect the
following:
When building up subassemblies and assembling the transmission, ALWAYS use new
gaskets and seals.
All fasteners must be ti ...
Disassembly
1. Remove the No. 1 selective pump support thrust washer.
2. Remove the front pump support.
1. Remove the bolts.
2. Remove the front pump support.
3. Remove the seal rings.
4. Remove the in ...
Other materials:
Flexplate
Removal and Installation
1. Remove the transmission. For additional information, refer to Section.
2. Remove the six bolts retaining the flexplate to crankshaft, and remove the
flexplate.
3. To install, reverse the removal procedure.
Tighten the bolts in ...
Refrigerant Identification Testing
Special Tool(s)
Refrigerant Identifier with Air-
Radicator
198-00003 or equivalent
1. NOTE: An A/C refrigerant analyzer must be used to identify gas
samples taken directly from the
refrigeration system or storage containers prior to recoveri ...
Master Cylinder - Hydro-Boost
Removal
1. Disconnect the fluid level sensor connector.
2. Disconnect the brake tubes.
3. Remove the brake master cylinder nuts.
4. Remove the brake master cylinder (2140).
Installation
1. To install, reverse the removal procedure.
Bleed the brak ...
