Ford Mustang (1999-2004) Service Manual: Rear Drive Halfshafts
General Specifications

Torque Specifications

Rear Drive Halfshafts (Description and Operation)
The rear wheel drive halfshaft system consists of and operates as
follows:
Halfshafts (4K138) transmit engine torque from the rear axle housing to
the rear wheels.
Halfshafts rotate at approxi ...
Other materials:
Camshaft Position (CMP) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the camshaft position (CMP) sensor.
Disconnect the connector.
Remove the bolts and the sensor.
Installation
1. To install, reverse t ...
Manual Control Lever Shaft and Seal
Special Tool(s)
Installer, Shift Shaft Fluid Seal
307-050 (T74P-77498-A)
Alignment Gauge, TR Sensor
307-351 (T97L-70010-A)
Removal
1. Drain the transmission fluid and remove the fluid pan and filter. For
additional information, ...
Headlamp exit delay
You can set the delay time to keep the headlamps on for up to three
minutes after the ignition is turned off.
Follow the steps below to change the delay time (Steps 1 through 6
must be done within 10 seconds):
1. Turn the ignition off.
2. Turn the lighting co ...
