Ford Mustang (1999-2004) Service Manual: Wheel Knuckle - Cobra

Special Tool(s)

Front Hub Remover 205-D070 (D93P-1175-B) or Equivalent

Steering Arm Remover 211-003 (T64P-9171-A)
Link - Stabilizer Bar
Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the sa ...

Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part ...

Other materials:

Multifunction Switch
Removal 1. Disconnect the battery ground cable. 2. Remove the ignition switch lock cylinder. 1. Insert the ignition key into the ignition switch lock cylinder and turn to RUN position. 2. Push the ignition switch lock cylinder release tab with a p ...

Installation
1. NOTE: This procedure applies to both the LH and RH halfshafts. Install a new driveshaft bearing retainer circlip. 2. Remove the special tool. 3. CAUTION: Differential seal damage will occur if installing the halfshaft without the special tool installed. ...

Removal
1. Remove brake master cylinder filler cap (2162). Check brake fluid level in brake master cylinder reservoir (2K478). Remove fluid until brake master cylinder reservoir is half full. 2. Raise and support the vehicle. 3. Remove the wheel and ...