Ford Mustang (1999-2004) Service Manual: Power Brake Actuation
Torque Specifications
- Brake Booster - Vacuum (Description and Operation)
- Brake Booster - Hydro-Boost (Description and Operation)
- Hydro-Boost Bleeding
- Brake Booster - Vacuum (Removal and Installation)
- Brake Booster - Hydro-Boost (Removal and Installation)
Control Valve
Removal
1. Disconnect the brake tubes.
2. Remove the brake fluid control valve bracket nut.
Installation
1. To install, reverse the removal procedure.
...
Brake Booster - Vacuum (Description and Operation)
Power Brake Booster
The vacuum type power brake booster (2005):
is a dual diaphragm, vacuum assisted power brake booster
reduces brake pedal force and travel distance.
is located on ...
Other materials:
Vehicle storage
If you plan on storing your vehicle for an extended period of time
(30 days or more), read the following maintenance recommendations to
make sure your vehicle stays in good operating condition.
All motor vehicles and their components were engineered and teste ...
Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear
General Specifications
Torque Specifications
Description
Nm
lb-ft
lb-in
Bolt retaining the differential pinion shaft to the
differential case
30
22
-
Bolt retaining the driveshaft yoke to the pinion flange
112
83
-
...
Air Conditioning (A/C) Compressor Bracket - 3.8L
Removal and Installation
1. Remove the A/C compressor (19703). For additional information, refer to
Air Conditioning (A/C)
Compressor-3.8L in this section.
2. Remove the three bolts and one nut.
3. Remove the A/C compressor mounting bracket.
4. To install ...
