Ford Mustang (1999-2004) Service Manual: Evaporative Emissions
General Specifications

Torque Specifications

- Evaporative Emissions (Description and Operation)
- Evaporative Emissions (Diagnosis and Testing)
- Canister Vent Solenoid Closing Procedure
- Evaporative Emission System Leak Test
- Evaporative Emission Repair Verification Drive Cycle
- Evaporative Emission Canister
- Evaporative Emission Canister Purge Valve
- Fuel Vapor Control Tube Assembly Valve
- Evaporative Emission Test Port
Charge Air Cooler
Material
Item
Specification
Silicone Gasket and Sealant
F7AZ-19554-EA or equivalent
WSE-M4G323-EA
Removal and Installation
1. Drain the supercharger coolant. For additional inform ...
Evaporative Emissions (Description and Operation)
Component Location
The evaporative emission system:
is equipped with an on-board refueling vapor recovery (ORVR) system.
prevents hydrocarbon emissions from reaching the atmosphere.
...
Other materials:
Evaporative Emission Canister Purge Valve
Removal and Installation
1. WARNING: The evaporative emission system contains fuel vapor
and condensed
fuel vapor. Although not in large quantities, it still presents the
danger of explosion or
fire. Disconnect the battery ground cable from the bat ...
Assembly
1. Install the valve stem seals.
2. Install the valves and the valve springs.
3. CAUTION: Make sure the tool is seated correctly on the valve spring.
Apply a small
amount of air at a time. This will prevent the tool from shifting and causing
damage to
the ...
Exhaust Manifold RH
Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to
Section.
2. Raise the vehicle. For additional information, refer to Section.
3. Remove the dual converter Y-pipe. For additional information, refer to
Sec ...
